销售热线 400-812-0328  |  微信同号 13798439218  |  WhatsApp +85251628371
欢迎光临本店 请登录  |  免费注册
当前位置: 首页 > 柯斯摩尔动态 > How to Inspect and Maintain a Foam Machine: Daily Checks on Drums, Hoses, Gun Head, Seals and Parameter Review
How to Inspect and Maintain a Foam Machine: Daily Checks on Drums, Hoses, Gun Head, Seals and Parameter Review
CosMolar / 2026-11-20

For a foam machine to produce consistent foam over the long run, daily inspection and periodic maintenance matter as much as correct operation. The material line, hoses and gun head directly affect ratio stability and forming quality; worn seals or impurities in the line can cause poor dispense, ratio drift or abnormal foam. This article walks through the main daily inspection and maintenance points.

Before start-up: drum level, temperature and hose condition

Before each start, check that A and B drum levels are sufficient, material temperature is in range, and drum lids and connections are sealed; inspect hoses for kinks, aging or leakage and confirm fittings are tight. Top up material when level is low and reseal against moisture after refilling; if a hose leaks or bulges, stop and repair it first rather than continuing under pressure.

During use: gun head cleaning and foam condition

The gun head is the key daily maintenance point: clean residual material off the head after each packing cycle to keep cured residue from blocking the outlet; watch whether dispense is even, whether the two streams meet normally, and whether rise and setting stay stable. If dispense slows, pulses, or foam turns brittle or uneven, check head blockage, line filter and material temperature first before deciding whether a wearing part needs replacement.

Periodic checks: seals, line cleaning and parameter review

On a usage cycle, review hose seals, fittings and wearing parts for wear; replace parts that have hardened or show leakage signs. Keep the material line and drums clean to keep impurities out. After a material or batch change or seasonal shift, review dispense volume, material temperature and placement rhythm, and confirm consistent forming on a trial pack before mass packing. When the machine will be idle long term, drain and clean the line and gun head per guidance to avoid cured residue blocking.

Support and response

CosMolar provides a one-year whole-machine warranty, with 4-hour phone response and 24-hour on-site service in the Pearl River Delta, and 48-hour response nationwide. During installation and handover we support foam calibration and operator training; after-sales guidance is available for daily inspection and maintenance questions. More equipment and consumable details at https://www.cosmolar.com/.

用户评论(共0条评论)

  • 暂时还没有任何用户评论
总计 0 个记录,共 1 页。 第一页 上一页 下一页 最末页
用户名: 匿名用户
E-mail:
评价等级:
评论内容:
验证码: captcha